1966-67 Fairlane floor shift hump location dimension
and Pictures. Submitted by: Scott Tanner
Hump in place: Hole in floor: Bucket seat hump brace and rear console mounting ears:
Hole in floor, factory cut with air chisel/panel
cutter ~1-1/2 to 2 from edge of hump all of the way around.. this hole was cut
freehand at the factory. Suggested that once hump is located, trace out around
onto floorpan, trace out holes, and measure in 1-1/2 to 2 all the way
around to locate the cut line.
Welcome To 
Woody's Fairlane Site !
